- Joined
- Feb 2, 2024
- Messages
- 29
So I had it working, and was going to show my father-in-law what I had been doing but when I went to turn it on it cut out again.
I found that KM1 doesn't stay engaged when when you lift the lever on the apron or push the inching/jog button. However, I can physically push in the black square on the KM1 until it engages and then hold KM2 or KM3 and it will run, but if I depress it fully to engage them KM1 will release.
@markba633csi Do you think this an apron switch issue or the KM1 contactor issue?
I found that KM1 doesn't stay engaged when when you lift the lever on the apron or push the inching/jog button. However, I can physically push in the black square on the KM1 until it engages and then hold KM2 or KM3 and it will run, but if I depress it fully to engage them KM1 will release.
@markba633csi Do you think this an apron switch issue or the KM1 contactor issue?