E
ecdez
Forum Guest
Register Today
I havn't seen "the streets" in quite some time 
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
E
ecdez
Forum Guest
Register Today
A little more progress today. I shaved 1" off the bottom so I should have 5" between the table and spindle when it's all back together. It's not a lot but it's more than 4". I was able to square the knee up by running the shim that was in it over the belt sander and shaving it down little by little until I got it close enough. Not bad for a homemade jobber.
Still have more to do though. It's not quite ready to make chips yet.
Still have more to do though. It's not quite ready to make chips yet.