- Joined
- Mar 10, 2012
- Messages
- 1,368
Pics?! What is this, Miss America Lathe pageant?! j/k Actually, I did take some pics but they're on my phone and I'm too tired to go get it and u/l them. Tomorrow. Well G-man, I got the end gear off the spindle finally. Used a 32mm socket that I milled down to about 1/2" height so I could get my gear puller over it and get the arms under the gear. The spindle's pretty clean, the insides of the cone and the bearings look good.
Greg (and of course anyone else that'd care to chime in), did you replace that thin metal washer that sits between the take-up nut and the rear expander with a thrust bearing? IIRC guys have done that but I don't know if that pertained to certain makes/years of the H10...
Greg (and of course anyone else that'd care to chime in), did you replace that thin metal washer that sits between the take-up nut and the rear expander with a thrust bearing? IIRC guys have done that but I don't know if that pertained to certain makes/years of the H10...