ER 40 Collet Chuck Runout

that is what I have been measuring--the taper.
Can you show a picture of how you are measuring the taper? The R8 section is locked down, correct? And the ER chuck is empty, without the nut? And you are simply using a DTI to measure TIR of the ER taper? And you are rotating the spindle by hand? Sorry for the elementary questions, but it's important to unravel the puzzle.
 
Can you show a picture of how you are measuring the taper? The R8 section is locked down, correct? And the ER chuck is empty, without the nut? And you are simply using a DTI to measure TIR of the ER taper? And you are rotating the spindle by hand? Sorry for the elementary questions, but it's important to unravel the puzzle.
yes to everything above
 
I made some videos for the glacern guys--they ended up giving me a refund

this is one of my R8 collets w and end mill, just for reference

this is the glacern ER40

and with my drill chuck and an end mill

and finally the spindle itself
FYI, your link (at least for the Glacern ER40) require your approval. They are not open links. If that's what you intended, that's fine.
 
Final update--ordered an ER40 chuck from little machine shop. .0002 TIR on inside face. Good enough for me.
 
Back
Top