- Joined
- Sep 22, 2010
- Messages
- 7,220
Hey guys,
This topic was discussed on another forum, but I didn't see a definitive answer, so I thought I'd ask here. If you have to turn a part with a shoulder at each end, where the gap between shoulders was only about 35mm long, and the height of the flange/shoulder was about 8mm (35mm large diameter, 27mm small diameter) in mild steel, how would you set it up to accomplish it?
Thanks,
Nelson
This topic was discussed on another forum, but I didn't see a definitive answer, so I thought I'd ask here. If you have to turn a part with a shoulder at each end, where the gap between shoulders was only about 35mm long, and the height of the flange/shoulder was about 8mm (35mm large diameter, 27mm small diameter) in mild steel, how would you set it up to accomplish it?
Thanks,
Nelson