- Joined
- Nov 16, 2012
- Messages
- 5,596
Actually... I been thinking about that a lot. If you look in there, I put a shoulder step in there to prevent the race from seating completely flat at the face. My initial thought was that a small gear puller mechanism could be used to pull it out. In hindsight, I've never seen a puller that small and would probably need to make something. -So only then, after I got a chance to lay eyes on it, did I start thinking about a couple screw holes.
I'm thinking screw holes would make life a lot easier but, I haven't researched the oil seals yet and don't know if they'll be large enough to cover-up the screw holes.
---Still thinking about this one... And I might just make a special tool to remove the race....
Ray
I'm thinking screw holes would make life a lot easier but, I haven't researched the oil seals yet and don't know if they'll be large enough to cover-up the screw holes.
---Still thinking about this one... And I might just make a special tool to remove the race....
Ray
Just a thought, but have you considered putting a couple of holes through for bearing race removal?