- Joined
- Dec 26, 2012
- Messages
- 63
Hi guys,
Just back from London, hence the delay..
Re. gears for the Chipmaster, I see from the manual that even the gears in the standard config for the inch version allows some metric threads. As I understand, there are extra gears allowing a further number of threads to be cut.. Are they the same as available from rdgtools in the UK?
http://www.rdgtools.co.uk/acatalog/Gears_for_Colchester_Bantam_Chipmaster_Lathe_.html
Thanks for the hints on where to source oils!
Also, thanks for the invitation.. don't be surprised if I turn up in Hvittingfoss!
Kind rgds
Jan Sverre
Just back from London, hence the delay..
Re. gears for the Chipmaster, I see from the manual that even the gears in the standard config for the inch version allows some metric threads. As I understand, there are extra gears allowing a further number of threads to be cut.. Are they the same as available from rdgtools in the UK?
http://www.rdgtools.co.uk/acatalog/Gears_for_Colchester_Bantam_Chipmaster_Lathe_.html
Thanks for the hints on where to source oils!
Also, thanks for the invitation.. don't be surprised if I turn up in Hvittingfoss!
Kind rgds
Jan Sverre