- Joined
- Sep 27, 2014
- Messages
- 3,123
i now have two face mills and they use tmg inserts ?. "Hopefully they don't go extinct "
The inserts that were in the mills have a ground flat on the radius all three sides.
I ordered some TMG 322 inserts for one mill , they don't have a flat on the radius.
Is there a code for face mill inserts with the flat on one side of the radius?.
Also arbors for them , I have a r8 and a 3/4" straight shank that should fit the mill head , witch would you use
If you look at the insert tip you can kinda see the flat by the radius , pic not real good
And the arbors, wondering why center one is split on end
Thanks.
The inserts that were in the mills have a ground flat on the radius all three sides.
I ordered some TMG 322 inserts for one mill , they don't have a flat on the radius.
Is there a code for face mill inserts with the flat on one side of the radius?.
Also arbors for them , I have a r8 and a 3/4" straight shank that should fit the mill head , witch would you use
If you look at the insert tip you can kinda see the flat by the radius , pic not real good
And the arbors, wondering why center one is split on end
Thanks.