H
Hukshawn
Forum Guest
Register Today
I acquired this 1 1/8" drill bit. The cutting end is nice, I was able to grind that back to a nice chisel point but the chucking end is chowdered. The drill will not chuck straight. And, the bore of my lathe is too small to even attempt to chuck nor do I even think it's possible to grab it.
Any options or is this just junk?
I'm not remotely attached to this drill. Just a nice big drill to have.
Any options or is this just junk?
I'm not remotely attached to this drill. Just a nice big drill to have.