Qctp Rack Sytem

[hman]

Here is my ugly but functional holders.View attachment 111254

Actually, I think they look pretty nice. The "bow tie" effect is pretty neat. Nice, functional design.

 

[chefjuke]

Gunrunner you need to order a set of these for the Z axis hand crank. Bill did you just spit coffee on your monitor? :rofl:

View attachment 253356

 

[kd4gij]

I quit building racks. Some one always fills them with every thing but what the are meant fore.

 

[paul s]

Here's my entry - just some hardwood scrap:

 

[RickKr]

Went rotary... and vertical...

3" diameter steel tube suspended on bearings, three hangers around the circumference. 32 toolholder capacity, including 8 boring bar holders, footprint about 1 sq. ft. Initially mounted from the joists in my basement for the pre-WWII Rivett 1020. Later, revised to sit on the table at the end of my Monarch 10EE, with a few extras sitting on the baseplate.