• Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!

  • In order for the Member Map to work properly, you must allow Google services AND Hobby Machinist to know your location. These settings are found in your browser of choice and in your Hobby Machinist profile.

Winner Home Grown Cutter Grinder

  • Thread starter Thread starter Bill Gruby
  • Start date Start date
Status
Not open for further replies.
Most sharp edges will be softened before we are done. It's quicker to do them all at once.

"Billy G"
 
Had an after thought to add these lock nuts in case one decided to back off while in operation. Now they are done. That's it for today folks. Hope you are having as much fun as I am.

"Billy G"

102_0565 (800 x 531).jpg
 
Last edited by a moderator:
While I have a little waiting time I am going to change all the stop adjustment screws to look like the pivot ones. It will really dress the grinder up.

"Billy G"
 
I had forgotten that I by-passed this "Kidney" shaped hole earlier in the build. It's for clearance to the "Binder" on the tower shaft.

"Billy G"

102_0568 (800 x 531).jpg 102_0569 (800 x 531).jpg 102_0570 (800 x 531).jpg
 
After some paint slinging this morning this is what that unit looks like.

"Billy G"

102_0571 (800 x 531).jpg
 
I was just looking at the build. Coming along very nice. Maybe you should put some nylon tips on your adjustment screws so they do not scratch your nice paint job.:))

Stan
 
Status
Not open for further replies.
Back
Top