Does anyone have the generic 2" or 3" boring head that is sold by the various tool companies? I've read elsewhere on the 'net that there were "issues" w/ the internal hex on the adjusting screw. I asked the OP of that thread but never got a reply. If you have 1 of boring heads how is the hex on the adjusting screw on the boring head? There has been another thread where the poster was wanting to replace the screw by making a new one w/ a better internal hex.
Looking @ the Grizzly & KBC catalogs, it appears that both companies (haven't checked Wholesale Tool yet) sell the same boring heads & kits, (albeit cheaper at Grizzly). I'm going to the States in a few weeks & may purchase one. If there are issues w/ this tool I'll look elsewhere.
Thanks in advance
Looking @ the Grizzly & KBC catalogs, it appears that both companies (haven't checked Wholesale Tool yet) sell the same boring heads & kits, (albeit cheaper at Grizzly). I'm going to the States in a few weeks & may purchase one. If there are issues w/ this tool I'll look elsewhere.
Thanks in advance