- Joined
- Jun 20, 2024
- Messages
- 5
Hello! I just purchased my first lathe, an EMCO C8, and am getting everything cleaned up and organized. It was rust free for the most part, but some of the tooling, etc. had some rust here and there. I've removed that with Evaporust and not knowing otherwise, shot the parts with a light coat of WD-40 to keep them from flashing rust until I know what to coat them with. Should I just use way oil for that? I see there is a lot of debate on the use of grease on chuck internals - I'm really asking about rust prevention moreso on those as well as centers, tooling, etc. Any suggestions?