All I seem To Do Lately Is Take Things Apart

[projectnut]

The maximum crosscut is supposedly 29". However, the maximum rip width is supposedly 41".

One source mentions the table is supposed to be 36" wide by 44" deep. I don't believe the width is correct since the metal base is 38" wide at the point where the leveling points are located

 

[projectnut]

Well, I'm finally making progress. The radial arm saw is complete, the drill press is reassembled and running, all but 2 of the treads on the deck stairs are complete, and I've finally started working on the generator. Tomorrow I should finish up the stairs which will leave one day of the holiday weekend for a little fun, and then back to work again.

Here's a picture of the final assembly of the drill press. There wasn't enough head room between the bench and the rafters to stand up, so I put a 5-gallon bucket on the bench and sat on it.