2015 POTD Thread Archive

Very nice work and design on your welding table, Bob.

Are the slotted tubes pictured for an extension arm?
 
Finished up my new welding table this afternoon. Should have built it a lot sooner, the old one I have been using was way too small and not flat at all.

Looks great. I especially like the color! :)


Sent from my iPad using Tapatalk
 
barn door channel.jpg That is a really nice welding table Bob. I think that channel must be for sliding doors, we have them on our horse stalls.
 
Last edited:
I don't know how to quote from my phone but, btw nice handles bud.
I was just rib stickin you about turning haha
 
View attachment 113974 That is a really nice welding table Bob. I think that channel must be for sliding doors, we have them on our horse stalls.

Thanks catskinner. Actually they are for a table extension on the vise end. I used some of the 2X2 tubing and milled a 1/2 slot down the middle. The pics don't show the extension part, I am building it today.
 
Very nice work and design on your welding table, Bob.

Are the slotted tubes pictured for an extension arm?

Thanks Franko, and yes you are correct. I am making the extension pieces today. All I have left is to drill a series of holes in the table. Rented a 3/4" chuck mag drill last week to countersink the bolts on the table but it had so much slop in the dovetails I decided to wait until I could find a better mag drill.
 
Is that 1/2" slot wide enough for the guard of those grinders to fit or just the wheel. Either way it is a great way to hang the grinders below the surface of the table.
:aok:
 
Back
Top