Was the block in the center of the vise ?ok, i was able to use a 1-2-3 block in the vice and measured .001" from one end of the 3 inch side to the other.
seems like a lot for such a short travel; any thoughts?
Can you post pics of the set-up ?could not have put it in the center and still indicated. i have it laying flat on the 'floor' of the vice
Put some parallels under the block and put it in the center of the vise.this is the setup...
View attachment 347180
If your X is in, the Y will be, unless the vise or machine is off.copy that!
@Joe Pie is the man when it come to set-ups.using the parallels worked like a champ; i am down to about 1/2 thou.
Thank you Jim F
Am also going to check out the video link you just sent...