Thanks for the contact Nelson. I'll get with him.
Chips, aside from the general purpose portion of the shop, which isn't all that large, compared to like Randy's or Paco's, I have roughly a 10 x 10 area set aside for electronics service/repair/building. I hate to think of it, but I may have to try and figure out a way to make that space workable for clock work too. As disorganized as it is currently, if you saw it you'd think it impossible, but when it is cleaned up, and I sell off some (all) of the duplicate instruments (who needs 3 scopes, 4 signal generators, 6 tube testers, 2 cap checkers, etc.?) there might be room to set up a small extra workbench with the lathe on it. Not sure what I'll do for gear making. I guess I could still use the rest of the shop when needed. At this point, that area is not walled off, but I have often thought of enclosing that area just to keep it clean, if nothing else. It might be a good idea if I start getting serious about timepiece work.