I'm thinking of getting a larger mill than my LMS benchtop. I want more table size and, mostly, travel. I want VFD, power x-axis and a DRO.
My 1340GT is 3-phase and I installed Mark's VFD. I see the 935 can be ordered with single or 3-phase, both with a VFD. Is there an advantage to one over the other? Should I get 3-phase and put on my own VFD? I'd really rather not spend the time doing that if I can help it.
Thoughts for those that have done this?
My 1340GT is 3-phase and I installed Mark's VFD. I see the 935 can be ordered with single or 3-phase, both with a VFD. Is there an advantage to one over the other? Should I get 3-phase and put on my own VFD? I'd really rather not spend the time doing that if I can help it.
Thoughts for those that have done this?