Just got my PM 1127 last week too(Also bought a mill). Pictures of both below.
PM recommended SAE 80-90 gear oil, so I bought Lucas LUC10043 on amazon. Showed up in two days. Fortunately, my gear box was full. Now I'm adjusting the lathe. Did an average job of levelling it. Now I'm chasing .003 of taper over 10". Might have to start over with my levelling. Mill was much easier to level within a half a thou.
View attachment 333240View attachment 333241
Yeah, I haven't got that far yet, however does look like we had same thought on table I looked for the one with center leg
could not find it local.
My gearbox and the cross slide both very low on oil, did you fill yours up to top of sight glass or middle of glass?