Personally, unless, (or until) you need to use that particular bar, I would leave it as is, apart from checking clearances and rake. You might find its just the right shape for some future job.
Personally, unless, (or until) you need to use that particular bar, I would leave it as is, apart from checking clearances and rake. You might find its just the right shape for some future job.
I recently bought a few "imports" cheapies.... For the most part, they were OK, one of them, when I pealed the coating off the carbide came with it. I had to re-braze it back on and touch it up a bit.
I recently bought a few "imports" cheapies.... For the most part, they were OK, one of them, when I pealed the coating off the carbide came with it. I had to re-braze it back on and touch it up a bit.
I recently bought a few "imports" cheapies.... For the most part, they were OK, one of them, when I pealed the coating off the carbide came with it. I had to re-braze it back on and touch it up a bit.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.