- Joined
- May 6, 2012
- Messages
- 116
+1 on Fusion 360
I recently switched to it. I have been using CAD since the 90's, and found the learning curve pretty painless.
It is a pretty powerful program, and pretty intuitive.
I generally prefer to start with a 2D sketch and extrude it to 3D, and it works very well for this. I have not played much with it starting from primitive solids, but what little I did was pretty simple and easy. It is certainly much easier to learn than 3DSMax.
Thanks for the heads up. I have a limited time to learn a conceptually different system but I will check it out.
Jim