Which Knee Mill, 3/4 Size?

[IamNotImportant]

My garage is from the floor to the ceiling is 6 feet and 10 inches.. that is all the room i have in the vertical plane, with that, which knee mills should i be looking for on the used market that will fit in this space without issues?

Thanks in advance.

 

[talvare]

I would try to find a Burke Millrite. Check out this video. At about the 7 minute mark he addresses height.

Ted

 

[IamNotImportant]

I would try to find a Burke Millrite. Check out this video. At about the 7 minute mark he addresses height.

Ted

yes.. i have found one, waiting to hear back from the owner.. It's a MV-1

 

[Steve-F]

I would love one of those!!

 

[IamNotImportant]

i have considered these Millrite mills, but are there others to be looking at as well?

 

[frugalguido]

Or find a Deckel or a Maho, they are low in height.

 

[IamNotImportant]

Or find a Deckel or a Maho, they are low in height.

thank you for that suggestion sir

 

[matthewsx]

The Burke’s are hard to find so if you have a good line on a decent one I’d go for it.

Would love to find a Deckel, would also like a winning lotto ticket

@davidpbest has some thoughts about small knee mills vs. bench (RF45) type mills which would easily fit your space.

John

 

[talvare]

Or find a Deckel or a Maho, they are low in height.

Ya, those are REALLY nice machines. But, you might have better luck trying to find another Hope Diamond !
Ted

 

[Weldingrod1]

Rockwell and Clausing are both short.

Sent from my SM-G892A using Tapatalk