Transfer case linkage modification

[DavidR8]

Not this Canuck, witness my descent into machine mania!

 

[Janderso]

Done.
As usual, the set up time took longer than the easy operation by far.
As big as this mill is, I ran out of room to use the co-axial indicator.
I used the sight by eye method with scribe lines and a pointer.
Came out perfect.

 

[Janderso]

I believe the threaded stud is the wat to go. Perhaps hold the top section of the shaft in a collet to align it, then clamp it down.

I tried the collet method. When I eyeballed it after setting zero I was off by about .010"
I don't think I tightened up the collet though. That would have done it.
Threaded stud idea gets the nod.

 

[Janderso]

witness my descent into machine mania!

I believe the term is ascent, "the act of rising or mounting upward"
Tomatoes-tomatoes

 

[vtcnc]

I believe the term is ascent, "the act of rising or mounting upward"
Tomatoes-tomatoes

Both directions result in a depleted bank account and spouses who question our judgement.


Sent from my iPhone using Tapatalk

 

[Janderso]

Both directions result in a depleted bank account and spouses who question our judgement.

Hmm, you may have a point there.