Small Vice

[Larry$]

Very useful little vices. The one I have looks very much like the one you got. Here being used to hold the work at an angle to drill & tap a set screw hole. I made the cross pin longer so I could get hold of it easier. It has the Shars name on it. Also made the internal part so it would stay inplace to make it easier to locate the pin through it.

 

[GRP]

Finally got around to setting up the vice. Seems like it holds the work well enough, though I've only taken light cuts with it so far with my face mill. Definitely need to make some toe clamps though. The clamps I used get in the way of the parallels because the vice is rather short.