-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Bought An Old Molo, But Not What I Expected?
- Thread starter great white
- Start date
- Joined
- Nov 15, 2014
- Messages
- 21
Jack,
This would only be found in MOLO 1937V1 (well, it is probably also in 1937V0, but I have never seen one of those). I found a fairly decent PDF of it somewhere on the Internet (I didn't do the scanning and some pages are a little crooked). The complete manual is nearly 100 MB but I just extracted Part 7 and it is about 16 MB. Pages are formatted to 8-1/2 x 11. I just uploaded it to DOWNLOADS. It is in the Atlas-Craftsman area, under \Manuals\Atlas MOLO.
This would only be found in MOLO 1937V1 (well, it is probably also in 1937V0, but I have never seen one of those). I found a fairly decent PDF of it somewhere on the Internet (I didn't do the scanning and some pages are a little crooked). The complete manual is nearly 100 MB but I just extracted Part 7 and it is about 16 MB. Pages are formatted to 8-1/2 x 11. I just uploaded it to DOWNLOADS. It is in the Atlas-Craftsman area, under \Manuals\Atlas MOLO.
- Joined
- Dec 1, 2012
- Messages
- 28
I just picked up the 16th edition, Circa 1955. In very good condition.
- Joined
- Nov 15, 2014
- Messages
- 21
That is still OK for the change gear 10F so long as it has Timken bearings and a horizontal countershaft. Coverage of vertical countershaft and babbit bearings was removed with this revision, and coverage of the QCGB was added.