- Joined
- Mar 26, 2014
- Messages
- 1,593
69.47mmOD and 48.26mm ID
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Anyone know where I can get a thrust bearing for a Hardinge Sjogren speed chuck?
- Thread starter wired
- Start date
Not even close to being an available metric size.
- Joined
- Apr 14, 2014
- Messages
- 3,546
Another source to check is: https://www.locateballbearings.com/
They specialize in hard to find and obsolete bearings. They're not your typical bearing distributor in that they buy out closed businesses and overstock from existing businesses. I found the bearings for the AllSpeed drive in my Sheldon lathe from them for a fraction of the price other distributors were asking.
They specialize in hard to find and obsolete bearings. They're not your typical bearing distributor in that they buy out closed businesses and overstock from existing businesses. I found the bearings for the AllSpeed drive in my Sheldon lathe from them for a fraction of the price other distributors were asking.
Unfortunately there isn't a single marking on that bearing.
- Joined
- Nov 25, 2015
- Messages
- 10,032
When I was trying to figure out what bearing it was, I came across a post of someone that took his chuck apart and mentioned one of the races was stuck to the housing due to a build up of gunk. You may have a race that is stuck and looks like the housing is the second race, but it actually is a separate piece.
- Joined
- Nov 25, 2015
- Messages
- 10,032
is that a new type of bearing... supply your own balls? Those races don't look very nice.
Similar threads
