- Joined
- Apr 28, 2014
- Messages
- 3,594
Re: POTD - Finally making some chips
Making up some new shackle plates for the Jeep®. It's taken more than a day of course.
I'm hoping these will support the springs a tad better than the stock ones. More 'bearing' surface
against all the parts.
Wore out the spindle on the mill I fear. (See Posting) Spindle rebuild to add to the list...
I wanted to face them to remove the scale so I did them up in the lathe on a 4-jaw.
Note to self - don't mess with answering the phone while clamping... (see picts)
I did get the Lil Mister going, that makes all the difference on my mill finish.
Good thing the mill is by the overhead door, the fog was getting to me.
I'm going to need to modify it to Terry's design I figure.
But at least I feel like I finally made something proper.
Making up some new shackle plates for the Jeep®. It's taken more than a day of course.
I'm hoping these will support the springs a tad better than the stock ones. More 'bearing' surface
against all the parts.
Wore out the spindle on the mill I fear. (See Posting) Spindle rebuild to add to the list...
I wanted to face them to remove the scale so I did them up in the lathe on a 4-jaw.
Note to self - don't mess with answering the phone while clamping... (see picts)
I did get the Lil Mister going, that makes all the difference on my mill finish.
Good thing the mill is by the overhead door, the fog was getting to me.
I'm going to need to modify it to Terry's design I figure.
But at least I feel like I finally made something proper.