1 ton arbor press for initial tool molding

[durableoreo]

I was out of line. I deleted the comment. My apologies to the OP.

 

[leonardo-albertovich]

@RJSakowski I actually looked into it because I agree with you about it being the absolute best option for my use case (it would be even better if I had an outlet in my storage unit as I would be able to actually do some minimal hammer forming) but I didn't wanted to deviate much from the basics, otherwise I would've ended up focusing on the wrong aspect and wasting time.

If the torch falls short I'll definitely go with the induction method because it's the best fit for my environment (and of course I'll report the results!).

@durableoreo no worries, everyone has bad days and I can see how my initial post could've struck a nerve in you. In any case, if you have any feedback or experience you'd like to share you are more than welcome.