Who needs more spindle bore?

12-14" should cover about all hobbiest needs? Buying a D1-2746 chuck is going to be expensive though, assuming the lathe doesn't come "fully tooled". And that special order XXA Aloris tool holder with the 4" insert tools. Wonder if it comes in single phase. That's a machine. Thanks for sharing.
 
I don’t think my engine hoist is going to work for this job...


Sent from my iPhone using Tapatalk
 
So, it a bench top lathe? The bench doesn't come with it? And no tail stock. Flat bed ways. No QCTP. And my track hoe is broken. I'm out. It was looking so good for a minute there. Wonder what they want for it.
 
What do you think goes here?
4ee221ba9985b4d7766565b73261bf78.jpg



Sent from my iPhone using Tapatalk
 
Dang it, didn’t see the flat bedways.
I was on the phone to my riggers...
And my concrete guy to pour another 6” concrete layer in my garage.


Sent from my iPhone using Tapatalk
 
I was wondering about that hole too. Maybe pump drive for power feed or power travel on the gear rack down the middle of the ways. Doesn't look like anything hooks to a shaft are something. But big equipment has some unique features I'm not familiar with.
 
You must log in or register to reply here.
Back
Top