- Joined
- Jun 12, 2014
- Messages
- 401
Edit: A rough cut 2x2 will not enter, corners too sharp and won't clear the radius. A modern SFS 2x2 goes in but rattles around in the square, about 1/8" clearance. I suppose an older one might fit. It does not have the patina I usually associate with woodworking tools.
Asking here but don't the exotic wood suppliers measure rough cuts by 1/8"? So a full inch would be "8/8s", and an inch and a half would be "12/8s"?
It could be most anything. My guess is someone had a large batch of big square nuts to make, so they made this fixture.