This is for any Tida owners out there.
The manual for my new-to-me model 4A says that it has a MT 5 head stock taper. After ordering a 5x2 and a 5x3 I found out tain't so. It is actually a bit of an oddall: an MT 4 1/2. Just so's you know.
I guess I'll keep the adapters any way for future machine aquisitions. Actually, it may fit my Royersford drill press. I'll also post this under the Asian section.
Al
The manual for my new-to-me model 4A says that it has a MT 5 head stock taper. After ordering a 5x2 and a 5x3 I found out tain't so. It is actually a bit of an oddall: an MT 4 1/2. Just so's you know.
I guess I'll keep the adapters any way for future machine aquisitions. Actually, it may fit my Royersford drill press. I'll also post this under the Asian section.
Al