Thread size on DTM 65A QCTP?

Sorry I didn't get back with you earlier. Mine is 9/16-18 thread and the PD measures .502". Hope that helps. Ken

EDIT: If you need a sketch of the post, let me know while I have it off the lathe..
 
What is the PD?

I don't need a sketch thanks. Almost got my post mounted.
 
What is the length of the stud sticking up? Looks like 1 3/4 inch high.
 
Cadillac STS said:
What is the length of the stud sticking up? Looks like 1 3/4 inch high.
Click to expand...
Just a couple hairs over 1-9/16" from the base top side of the tee to the end of the thread. If that made any sense.
 
Got it done. I ended up milling a 9/16 hole where the stock post was after pressing it out and just put a 9/16 18 bolt up through with a little modification to the bolt (Needed to place a pin in the bolt head so it wouldn't spin.) Very solid and noticeable difference compared to my other one. Problem with the other one may have been using that thiner stock post to mount it to and not having enough down force to keep it from moving.

It has smoother motion than the asian QCTP. Little taller so I have to re set all my tools for the DTM.

Thanks for all the help!
 
You must log in or register to reply here.
Back
Top