Tapping 10-24 in blind hole SS 304

How about using a roll-form tap? There are no chips with a roll-form.
 
I guess machine tap is not a precisely defined term. I always thought it referred to spiral flute tap that get be hard to keep straight by hand. Apparently this is not the case.
Robert
 
Salvor6 said:
How about using a roll-form tap? There are no chips with a roll-form.
Click to expand...
In a work-hardening stainless? That doesn't seem likely to end well.

Sent from my Pixel XL using Tapatalk
 
You must log in or register to reply here.
Back
Top