Taper attachment question

[Abody711]

You neglected to tell us what lathe you have, so the pertinent installation instructions can't be resolved.

Heavy 10

 

[gard]

Thanks for the information. Found a clearer copy of the form at http://vintagemachinery.org/pubs/1617/17785.pdf

Thanks for posting that, I have scraped in the cross slide dovetail, the gib is fitting nice, next I may have to go thru some of the checks in that document to adjust for the fact that the cross slide sits a little lower now. The SB 10L has what I assume is a factory installed taper attachment.