Photos of the switch.
I think I may need a different one.
This one does this.
left
And neutral nothing and right this.
There is no finger on the #6 position and does nothing but provide a handy place for connecting earth wires.
hope this what you meant.
Bruce
And if you want to go back to the old motor:
note: move switch wire from 4 to 3 if rotation is backwards from handle
As John Lennon told the Queen: "no need to applaud just rattle your jewelry"
o.k.
I will run it by you to make sure I understand.
To run the New motor.
I need to take the bridges off the motor connectors and wire up the motor and power lead as drawn.
The thermal cut out /reset to live wire from power supply?
Earths to pole #6
To run the old motor
I tried to copy or keep and edit and repost the old motor drawing but
If you take the wire from the number 4 red dot and connect that to pole #3 then this is how it is wired and runs at present.
I do not know if it correct but it is how I got it.
most Things needed To be put together properly and adjusted on the old girl anyway.
The wiring could be the same.
Thanks for the help
I would never been able to figure out how to wire it by myself.
As I don’t tend to play with the big boys stuff over 12 or 24volts if I can figure things out.
Cheers
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.