- Joined
- Jun 11, 2013
- Messages
- 731
I made a new drawbar for my benchtop mill. The whole project is covered in 6 minutes of video, most of it fast motion of my th54 lathe doing most of the actual work.
There are other ways to make a drawbar than turning it from solid hex stock, but I had some kicking around and I wanted to create some chips.
I knew the lathe was going to do most of the work, so taking video was pretty easy. Its the editing that takes all the time for a project.
There are other ways to make a drawbar than turning it from solid hex stock, but I had some kicking around and I wanted to create some chips.
I knew the lathe was going to do most of the work, so taking video was pretty easy. Its the editing that takes all the time for a project.
Last edited by a moderator: