• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.
  • PLEASE: Read the FORUM RULES BEFORE registering!

Project: New drawbar for my benchtop mill.

schor

Active Member
Active Member
Joined
Jun 11, 2013
Messages
709
Likes
179
#1
I made a new drawbar for my benchtop mill. The whole project is covered in 6 minutes of video, most of it fast motion of my th54 lathe doing most of the actual work.

There are other ways to make a drawbar than turning it from solid hex stock, but I had some kicking around and I wanted to create some chips.

I knew the lathe was going to do most of the work, so taking video was pretty easy. Its the editing that takes all the time for a project.

 
Last edited by a moderator:

Ken from ontario

Active Member
Active Member
Joined
Dec 26, 2016
Messages
514
Likes
369
#8
Great job Steve, it must have taken some time and effort to make this video, edit.add music ,etc. but you made it work.
 

schor

Active Member
Active Member
Joined
Jun 11, 2013
Messages
709
Likes
179
#9
I had hours of video to edit. Then I changed the music 3 times. Thanks for the comps.
 
Container Above bottom breadcrumb