I've now seen guys on videos using a table saw to do portions of the resawing work on every board! Start with
my basic "learning" board. (2x6 and 16 feet long, so it's true height is 5.5 inches) On a table saw make a full, 16' length, kerf cut,
2 inches deep, into one of the 1.5" wide edges.Then flip the board, and into the opposite 1.5" edge, make a second kerf cut 2 inches
deep, directly aligned with the first kerf cut. The result will be, that ONLY the center portion of the board remains to be cut with the
little Delta *10 inch bandsaw, and the thickness of that remaining wood is just 1.5", the same as any typical rip cut or cross cut!! Hooray!