Guys I am making a aluminum 4" dia hand wheel for the SB Fourteen lathe that will allow the reeves pulley to be adjusted.So I started turning the OD for the part of the hand wheel for a shaft.Next I wanted to drill a hole for the shaft so I look for my drill chuck but couldn't find it.Dang,I don't have one so this project is on hold till I get one.
Guys I am looking for some recommendations for a drill chuck,so I look on ebay for maybe a good used one and the no name drill chucks are all over the place and lots of Jacobs.Guys I can't spend 250.00 for a new/used one but I would like to find one that will hold a bit and can be easily remove without a hammer and chisel.What would you buy with limited funds that will do the job???Thanks guys for the help----kroll
Guys I am looking for some recommendations for a drill chuck,so I look on ebay for maybe a good used one and the no name drill chucks are all over the place and lots of Jacobs.Guys I can't spend 250.00 for a new/used one but I would like to find one that will hold a bit and can be easily remove without a hammer and chisel.What would you buy with limited funds that will do the job???Thanks guys for the help----kroll