how to make good fit?

[dontrinko]

got a good fit. Used a file and emery cloth. Take a little off ,test fit, etc until done. don

 

[tq60]

Tail stock of lathe?

Most are taper so what have you there?

Sent from my SAMSUNG-SGH-I337Z using Tapatalk

 

[Turnaround]

Used to polish ground crankshafts with a one inch strip of 320 grit spun on three pulley/electric motor. A new piece of 320 grit would take .001 off in just a couple revolutions. A used piece of 320 pr 400 might give a slow enough cut to ONLY cut .001. Go slow and measure every couple revolutions.


Sent from my iPhone using Tapatalk