The only reason I didn't just buy some lathe dogs is I want to turn some gun barrels and I didn't want to run the set screw into a stainless barrel. I really need to get an DRO installed it would have taken half the time.
Had a second to make a cut today. It looks like I'm .003 off in seven inches . Being larger at the tail stock I asume I need to come toward me on the adjustment ?
Ok I made another pass just taking off the error and as you can see the two sides read the same . The cutter was just cleaning the left not really cutting .
From here I need some long bar stock and cut the whole length ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.