So I’ve spent 2 full days and 4 fuses trying to figure this out. I’ve got a Dayton single phase, 115 or 220 volt, 30PT40 motor. I also have a Dayton 3 pole (6 pin?) drum switch (it’s the configuration as shown in the picture below) It’s being used to operate a bi-fold door, so the switch is used to bring it up or down. The issue I am having is that the diagram on the motor does not tell me where to connect my wires from the switch. I found a drawing someone made online, however there is no black wire coming out of the motor for me to connect up like the drawing says. Here’s the diagrams and drawing:
I have had it hooked up a couple different ways now, but it seems to be shorting out and blowing my fuse because the one power going into pin 1 is directly connected underneath to pin 2, one of my neutrals, but there’s no other pins to connect them to! I am at a loss here, any help would be greatly appreciated.
I have had it hooked up a couple different ways now, but it seems to be shorting out and blowing my fuse because the one power going into pin 1 is directly connected underneath to pin 2, one of my neutrals, but there’s no other pins to connect them to! I am at a loss here, any help would be greatly appreciated.