- Joined
- Oct 7, 2020
- Messages
- 2,117
I made a couple parts to convert my boring bar to a ball end turner. Here is the finished product. I purchased a 3/4" straight shaft arbor for the boring bar. I made the handle end cap so when it is tight there is just the slightest amount of drag.
I turned a piece for the cutter, 12mm one on end for the boring bar and 6mm for the for the RCMT 0602 cutters.
I'm planning on adding a handle, but it worked pretty well with just an Allen wrench in the end.
I did turn a little ball end just for kicks and grins.
Added a magnet and put it to use.
It's not finished yet, but it's all I got for now.
Thanks for looking.
Tim
I turned a piece for the cutter, 12mm one on end for the boring bar and 6mm for the for the RCMT 0602 cutters.
I'm planning on adding a handle, but it worked pretty well with just an Allen wrench in the end.
I did turn a little ball end just for kicks and grins.
Added a magnet and put it to use.
It's not finished yet, but it's all I got for now.
Thanks for looking.
Tim