I have an 8in x 8in x 1in steel plate I want to use for a project. It already has four 0.375in holes I want to plug, to make the plate "contiguous".
I'm thinking of drilling and tapping the four holes to 1/2-13 (0.4219in tap drill), then "slathering" JB Weld on bolts (or studs) spin them into the holes, sticking out a little proud on each side, then once the JB Weld cures, milling or fly-cutting down the surface of the plate.
Any other suggestions?
I'm thinking of drilling and tapping the four holes to 1/2-13 (0.4219in tap drill), then "slathering" JB Weld on bolts (or studs) spin them into the holes, sticking out a little proud on each side, then once the JB Weld cures, milling or fly-cutting down the surface of the plate.
Any other suggestions?