[How do I?] VFD help

Here's a video of the motor plate parameters input. Turns out the GT series doesn't display an "END" message after input, so I guess that issue is a non-issue. But I must be missing something simple that I'm just overlooking or not understanding. No power to the output terminals when I press run. Any direction would be greatly appreciated.

 
After beating my head against the wall (not literally) I sent an email request to HongKong along with the above video. They sent back a couple videos with the correct settings and presto, the Perske Spindle runs. Turns out there were more parameters to set than I realized.
 
Runs like a champ. And the Vector control gives me way more low end RPM control and torque than the old inverter.
 
Last edited:
What were the additional parameters that needed to be set? I'm having a similar issue with the same (series) vfd.

Thanks
 
You must log in or register to reply here.
Back
Top