- Joined
- Feb 14, 2016
- Messages
- 620
Nice job bosephus , a section of that would make a awesome table top for a small lathe .
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Toolbox Bling
- Thread starter bosephus
- Start date
finished up and bolted down ... woo hoo it sure is nice finally throwing the rubber mat i had on the box before onto the floor where it belongs .
i screwed up somewhere along the finishing process and somehow turned my semi gloss polyurethane into a high gloss finish . but a minute or two with some 0000 steel wool took care of that easy enough .
not only does it look pretty good , but the best part is i only have a grand total of $23 invested in it .
i screwed up somewhere along the finishing process and somehow turned my semi gloss polyurethane into a high gloss finish . but a minute or two with some 0000 steel wool took care of that easy enough .
not only does it look pretty good , but the best part is i only have a grand total of $23 invested in it .