Tapping Head

  • Thread starter Thread starter Bill Gruby
  • Start date Start date
OK then, it looks like a go. The one I have in mind was featured in Home Shop Machinist Vol. 20 #2 March/April 2001. There will be a few modifications to make it run smoother. I will post the build in the Members Projects Section.

"Billy G"
 
Last edited by a moderator:
Awesome Bill.
I'm willing to test it out to see if it works upside down in our neck of the woods.
 
I'll be watching that for sure, Bill. It will be a good project to launch the new shop next year.
 
Sounds like a great project and lots of interest.
For me, I would like to find out how to overhaul or troubleshoot the one I bought off eBay. It has some periodic malfunction on reversing and I am skeptical about opening it up and seeing what lies within. Looks like a factory rebuild is about half the cost of a new one and that's not in my budget.
Any clues as to that would be appreciated. PM me if you have any instructions for a tear down, operator manual ,etc on an SPD70 .
Thanks,
jasper
 
You must log in or register to reply here.
Back
Top