Small Atlas Lathe

It is all dismantled and the Bed is soaking in "Evapo-Rust". We will see in a couple of hours. Everything seems to be here except for the motor and drive sheeves.

"Billy G" :thinking:
 
1 hour, 10 minutes. Lookin good. There is hope for this old timer.

"Billy G" :))

bed 001 (700 x 525).jpg bed 002 (700 x 525).jpg bed 003 (700 x 525).jpg
 
Hi Bill. I have a 6" atlas like this I bought new a long time ago.It's boxed up at the moment as I am moving into a new shop.I will dig it out tomorrow and get the pulley sizes and post them if someone does not beat me to it.
Bill L.
 
Hi Bill

The motor pulley is 3 7/32----- 1 11/16
counter shaft 4 7/16----- 3 3/16
3L belts

Bill L.
 
Thanx Bill. Were these dimensions taken at the rim or in the valley?

"Billy G" :thinking:
 
Thank you Bill. I just printed the link as I need to pull the spindle. :man:


"Billy G" :))
 
That wood wedge is the trick. In putting my 618 back together I thought I would use a 3L300 belt because I had four laying around.....
Wrong, too short. I had a 3L360 but thought I'd order a 3L330. Worked ok. But I wished I had used a 3L340.... Now to turn that four step
countershaft pully as the small grove is broke...
 
You must log in or register to reply here.
Back
Top