Should I Get This Manual Sheet Metal Notcher?

Well I'm glad you've gone back into hunting mode Susan. 3n1 don't come up very often. All the ones I saw close by were rough to say the least. And I have yet to see anything that looks better in person than in a little pic on CL. The cheapest was $100 and it looked rode hard and put up wet. But mine was completely unused and on the original pallet so that's why I went for $230(down from $250, one of the few times I bargained). You should also keep an eye on HF because I'm sure that machine is going away sooner or later and you might be able to get a floor model. Hey, it could happen:encourage:
 
Hey Susan, I have a 3 in 1. It's ok, and it weighs as much as a toyota. You may have lost, but ya didnt lose big.
 
You must log in or register to reply here.
Back
Top