Newbie’s 1st lathe! I just bought a Craftsman 101.28970

jdeitch said:
I tried to fit the the square table on both the cross slide and the milling attachment without success. The dovetail on the table is too narrow. I would love to have the matching base for this table. If anyone has any info I would be very grateful.
Click to expand...

Sorry. I mis-identified the table from what the top-view photo looked like. I have never seen this table with the dovetail at 45 degrees to the slots. The bottom of the table that I thought it was is round with two locking screws at 90 deg. and a flat bottom hole just like those on the upper compound swivel and the milling attachment vise. There might be enough material there to convert it iff you can't locate the parts to restore it.
 
You must log in or register to reply here.
Back
Top